My project is moving along....slowly....
David Mankin sent me the security bit I needed to take the bottom off of the Salton popper.
Took half a minute to get it open.
Here's the inside of the bottom.
I have a toggle switch I want to add the the heater wires because I have read that small batches sometimes require/benefit from the extra heat.
And, this model doesn't seem to have the plastic harness that the wires connect through, so....
I'm wondering if anyone can suss out from the picture which wires go where.
Clearly the two blacks coming in from the southeast are the juice. Two small red wires go into northmost part the silver circular bit in the middle. (The on off switch is in the housing just beyond that, by the way)
And then three wires (red, white, black) go into the housing there at the southwest.
So....do I need to do another layer of removal to figure out what goes where? Looks like it would be simple enough to remove the circular bit (obviously I don't quite know what that is), and even the next layer of the inner plastic housing.
Did anyone understand a word of this?
Sorry