Green Coffee Buying Club
Coffee Discussion boards => Hardware & Equipment => Topic started by: Kifu on May 19, 2011, 08:09:40 AM
-
I just bought a used Ambex YM-15. I called Nordfab--the recommended ducting co. to go with--and they quoted me for over $1,300 for their "Ambex kit". This is crazy--I could install ducting in a house for that much! Does anyone know of any alternatives to this?
Please Help!
-
When I built my roaster I went to lowes and got double wall vent pipe used for gas water heaters, with a wall plate that keeps the heat 1" away from the walls. I thinks its fire safe but I also believe it not fire code for a roaster, could be a problem if you have a fire. I do not know if this vent pipe comes in a dia as big as a ym-15 would need.
good luck
Ringo
-
Lowe's and HD sell double wall class B ducting & fittings. As Ringo said the problem will be pass throughs, where walls & roofs must be pierced.
I'd find a local wood-burning fireplace store and see how much they'd charge to vent your Ambex. At least then you know it'll be up to local code and you won't have future insurance problems.
-
When I talked to the Nordfab rep, he told me I would be able to put my hand on the pipe at about 4' up from the base. He suggested not to use double-walled at the pass-through, unless I was sure I'd get pinned for it by an inspector.
I think I will call a local fireplace/chimney place.
-
When I talked to the Nordfab rep, he told me I would be able to put my hand on the pipe at about 4' up from the base. He suggested not to use double-walled at the pass-through, unless I was sure I'd get pinned for it by an inspector.
I think I will call a local fireplace/chimney place.
I did B-vent with flashing through the ceiling; no problem.